Rohde & Schwarz RTE Series - Page 1473

Remote control commands
R&S
®
RTE
1473User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:SPI:DPOSition <SearchName>,<DataPosition>
SEARch:TRIGger:SPI:DPOSition? <SearchName>
Sets the number of bits or words before the first word of interest, see also SEARch:
TRIGger:SPI:PALignment. These offset bits/words are skipped. The index 0 is
associated with the first data bit or word.
If the position operator defines a range, also define the last bit/word of interest using
SEARch:TRIGger:SPI:DPTO
Parameters:
<DataPosition> Range: 0 to 32767
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
Firmware/software: FW 3.30
SEARch:TRIGger:SPI:DPTO <SearchName>,<DataPositionTo>
SEARch:TRIGger:SPI:DPTO? <SearchName>
Sets the the end value of a data postion range.
Parameters:
<DataPositionTo> Range: 1 to 32767
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
Firmware/software: FW 3.30
SEARch:TRIGger:SPI:PALignment <SearchName>,<DataAlignment>
SEARch:TRIGger:SPI:PALignment? <SearchName>
Defines how the specified data pattern is searched.
Parameters:
<DataAlignment> WORD | BIT
WORD
The pattern is matched only at word boundaries.
BIT
Bit-by-bit: the pattern can start at any position in the message.
*RST: WORD
Parameters for setting and query:
<SearchName>
Usage: Asynchronous command
Firmware/software: FW 3.30
Protocols