Rohde & Schwarz RTE Series - Page 1528

Remote control commands
R&S
®
RTE
1528User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:CAN:SYMBolic:SSIGnals <SearchName>,<SymbolicSearch>
SEARch:TRIGger:CAN:SYMBolic:SSIGnals? <SearchName>
Enables the search for symbolic values if DBC label list file is loaded and applied.
Symbolic search disables all other search criteria.
Parameters:
<SymbolicSearch> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> String that contains the search definition name
SEARch:TRIGger:CAN:SYMBolic:SIGValue
<SearchName>, <SignalName>
SEARch:TRIGger:CAN:SYMBolic:SIGValue? <SearchName>
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
See also: TRIGger<m>:CAN:SYMBolic:SIGValue on page 1525
Parameters:
<SignalName> String that contains the symbolic signal name
Parameters for setting and query:
<SearchName> String that contains the search definition name
Example:
SEARch:TRIGger:CAN:SYMBolic:SIGValue "Search1","EngForce"
SEARch:TRIGger:CAN:SYMBolic:DMIN <SearchName>,<DataPattern>
SEARch:TRIGger:CAN:SYMBolic:DMIN? <SearchName>
Defines the minimum data pattern in a symbolic search.
To set the condition, use SEARch:TRIGger:CAN:DCONdition.
Parameters:
<DataPattern> Range: -100E+24 to 100E+24
Increment: 0.5
*RST: 0
Parameters for setting and query:
<SearchName> String that contains the search definition name
SEARch:TRIGger:CAN:SYMBolic:DMAX <SearchName>,<DataPatternTo>
SEARch:TRIGger:CAN:SYMBolic:DMAX? <SearchName>
Defines the maximum data pattern of the signal in a symbolic search.
This value is required to specify a range if condition INRange | OORange is set with
SEARch:TRIGger:CAN:DCONdition on page 1513.
Protocols