Rohde & Schwarz RTE Series - Page 1551

Remote control commands
R&S
®
RTE
1551User Manual 1326.1032.02 ─ 20
Parameters:
<IdParityError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SYERror <SearchName>,<SyncError>
SEARch:TRIGger:LIN:SYERror? <SearchName>
Searches for synchronization errors.
Parameters:
<SyncError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:CHKSerror <SearchName>,<ChecksumError>
SEARch:TRIGger:LIN:CHKSerror? <SearchName>
Searches for checksum errors according to the LIN standard.
Use the following commands to configure the checksum error search:
●
SEARch:TRIGger:LIN:ERRPattern on page 1551
●
SEARch:TRIGger:LIN:CRCDatalen on page 1552
●
SEARch:TRIGger:LIN:STANdard on page 1552
Parameters:
<ChecksumError> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:ERRPattern <SearchName>,<ErrorPattern>
SEARch:TRIGger:LIN:ERRPattern? <SearchName>
Sets the frame identifier to search for a checksum error.
Parameters:
<ErrorPattern> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076.
Parameters for setting and query:
<SearchName>
Protocols