Rohde & Schwarz RTE Series - Page 1575

Remote control commands
R&S
®
RTE
1575User Manual 1326.1032.02 ─ 20
Usage: Query only
BUS<m>:FLXRay:FRAMe<n>:CYCount?
Returns the number of the current FlexRay cycle.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<CycleCount> Range: 0 to 63
*RST: 0
Usage: Query only
BUS<m>:FLXRay:FRAMe<n>:CSSTate?
Returns the state of the cyclic redundancy check code of the header data.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<HdrCksumSt> OK | UVAL | INSufficient
OK: the CRC is valid.
UVAL: unexpected value
INSufficient: the frame is not completely contained in the acqui-
sition. The decoded part of the frame is valid.
*RST: OK
Usage: Query only
BUS<m>:FLXRay:FRAMe<n>:CSValue?
Returns the checksum value of the header CRC.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Protocols