Rohde & Schwarz RTE Series - Page 1579

Remote control commands
R&S
®
RTE
1579User Manual 1326.1032.02 ─ 20
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:CMAX <SearchName>,<CycleCountMax>
SEARch:TRIGger:FLXRay:CMAX? <SearchName>
Sets the the end value of a cycle count range if the condition SEARch:TRIGger:
FLXRay:CENable is set to INRange or OORange.
Parameters:
<CycleCountMax> Range: 0 to 63
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:CMIN
<SearchName>,<CycleCountMin>
SEARch:TRIGger:FLXRay:CMIN? <SearchName>
Specifies a cycle count - the number of the current FlexRay cycle - or sets the the start
value of an cycle count range.
Parameters:
<CycleCountMin> Range: 0 to 63
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:CSTep <SearchName>,<CycleCountStep>
SEARch:TRIGger:FLXRay:CSTep? <SearchName>
Specifies a step to search for each n-th cycle inside the given range. This allows for a
specific search if slot multiplexing is used.
The condition SEARch:TRIGger:FLXRay:CENable must be set to INRange or
OORange.
Parameters:
<CycleCountStep> Range: 1 to 63
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
Protocols