Rohde & Schwarz RTE Series - Page 1583

Remote control commands
R&S
®
RTE
1583User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:FLXRay:NUFRame <SearchName>,<NullFrame>
SEARch:TRIGger:FLXRay:NUFRame? <SearchName>
Searches for the null frame indicator bit, a frame without usable data.
Parameters:
<NullFrame> ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:PLPReamble
<SearchName>,<PayloadPreamble>
SEARch:TRIGger:FLXRay:PLPReamble? <SearchName>
Searches for the payload preamble indicator bit that indicates a Network Management
Vector in the payload segment.
Parameters:
<PayloadPreamble> ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:PCONdition <SearchName>,<PayloadLengthOp>
SEARch:TRIGger:FLXRay:PCONdition? <SearchName>
Sets the operator for the payload length search setting. You can defined an exact
value, or a range.
Parameters:
<PayloadLengthOp> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The payload length is not relevant for the search condition.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one payload
length to be set with SEARch:TRIGger:FLXRay:PMIN.
INRange | OORange
In range, Out of range: Set the minimum and maximum value of
the range with SEARch:TRIGger:FLXRay:PMIN and SEARch:
TRIGger:FLXRay:PMAX.
*RST:
OFF
Parameters for setting and query:
<SearchName>
Protocols