Rohde & Schwarz RTE Series - Decode Results

Remote control commands
R&S
®
RTE
1601User Manual 1326.1032.02 ─ 20
Suffix:
<n>
.
1..4
1 if trigger type is DATA or WINDow
Specifies the condition number if trigger type is CONDition:
– 1 | 2 for I²S standard, left- und right-justified data formats
– 1 | 2 | 3 | 4 for TDM signals
Parameters:
<DataMaxPattern> Numeric pattern in 2's complement format. See also: Chap-
ter 18.4.6, "Bit pattern parameter", on page 1076
DMAX must be greater or equal than DMIN.
X bits are not allowed. If the bit string is shorter than the word
length, the rightmost bit of the input bit string is aligned to the
rightmost (LSB) bit of the word.
TRIGger<m>:I2S:SOWords
<SequenceOfWords>
Sets the number of words that is used as time limit for the "Window" trigger type. The
instrument triggers if the data condition is fulfilled on the same channel for the given
number of subsequent frames.
Parameters:
<SequenceOfWords> Range: 1 to 1000000
Increment: 1
*RST: 1
Default unit: word
Usage: Asynchronous command
TRIGger<m>:I2S:WSSLope <WSSlope>
Sets the edge of the WS or FSYNC signal as trigger condition. The instrument triggers
on the first clock edge after the specified edge.
Parameters:
<WSSlope> POSitive | NEGative
*RST: POSitive
Usage: Asynchronous command
18.17.9.3 Decode results
BUS<m>:I2S:FCOunt?................................................................................................. 1602
BUS<m>:I2S:FRAMe<n>:STATe?..................................................................................1602
BUS<m>:I2S:FRAMe<n>:STARt?..................................................................................1602
BUS<m>:I2S:FRAMe<n>:STOP?.................................................................................. 1602
BUS<m>:I2S:FRAMe<n>:LEFT:VALue?......................................................................... 1603
BUS<m>:I2S:FRAMe<n>:RIGHt:VALue?........................................................................1603
BUS<m>:I2S:FRAMe<n>:LEFT:STATe?......................................................................... 1603
Protocols