Rohde & Schwarz RTE Series - Page 1634

Remote control commands
R&S
®
RTE
1634User Manual 1326.1032.02 ─ 20
BUS<m>:ARINc:MAXGap:BITS <MaxGapBits>
Sets the value for the maximum gap between two words.
See also: BUS<m>:ARINc:MAXGap:SELect
Suffix:
<m>
.
1..4
Parameters:
<MaxGapBits> Range: 0 to 1000
Increment: 1
*RST: 100
Default unit: bit
BUS<m>:ARINc:MINGap:SELect
<MinGapSelect>
Enables the detection of the minimum idle time between two words during decoding.
To specify the minimum gap, useBUS<m>:ARINc:MINGap:BITS.
Suffix:
<m>
.
1..4
Parameters:
<MinGapSelect> ON | OFF
*RST: ON
BUS<m>:ARINc:MINGap:BITS <MinGapBits>
Sets a value for the minimum timing gap between two words.
See also: BUS<m>:ARINc:MINGap:SELect on page 1634.
Suffix:
<m>
.
1..4
Parameters:
<MinGapBits> Range: 0 to 100
Increment: 1
*RST: 4
Default unit: bit
BUS<m>:ARINc:POLarity <Polarity>
Sets the wire on which the bus signal is measured.
Suffix:
<m>
.
1..4
Parameters:
<Polarity> ALEG | BLEG
*RST: ALEG
Protocols