Rohde & Schwarz RTE Series - Page 1652

Remote control commands
R&S
®
RTE
1652User Manual 1326.1032.02 ─ 20
TRIGger<m>:ETHernet:FRAMe:DMIN............................................................................1655
TRIGger<m>:ETHernet:FRAMe:SCONdition...................................................................1655
TRIGger<m>:ETHernet:FRAMe:SMAX...........................................................................1655
TRIGger<m>:ETHernet:FRAMe:SMIN............................................................................1655
TRIGger<m>:ETHernet:FRAMe:TCONdition...................................................................1656
TRIGger<m>:ETHernet:FRAMe:TMAX...........................................................................1656
TRIGger<m>:ETHernet:FRAMe:TMIN............................................................................1656
TRIGger<m>:ETHernet:TYPE <Type>
Selects the type of frame to be triggered on.
Suffix:
<m>
.
1..3
Parameters:
<Type> STARt | PATTern | ADVFrame | ADVCerror
STARt
Selects to trigger for the start of frame: search for the preamble
and set the trigger instant thereafter.
PATTern
Selects to trigger for a bit pattern (data) to be specified in
TRIGger<m>:ETHernet:PATTern on page 1652.
ADVFrame
Sets the trigger to the advanced frame. You can further define
the values of the frame.
ADVCerror
Sets the trigger to advanced error. You can further enable the
error conditions you want to trigger on.
*RST:
STARt
TRIGger<m>:ETHernet:PATTern <DataPattern>
Specifies the bit pattern (or data) that is to be triggered.
Suffix:
<m>
.
1..3
Parameters:
<DataPattern>
TRIGger<m>:ETHernet:ERRor:CRC <ErrorCRC>
Enables the trigger on a mismatch of the cyclic redundancy check (CRC) value
between the transmitting and receiving device.
Suffix:
<m>
.
1..3
Protocols