Rohde & Schwarz RTE Series - Page 1721

Remote control commands
R&S
®
RTE
1721User Manual 1326.1032.02 ─ 20
Parameters:
<ErrorCondition> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:TTYPe <SearchName>,<TSFieldType>
SEARch:TRIGger:SENT:TTYPe? <SearchName>
Selects the SENT transmission sequence to be searched for.
To enable the search for the transmission sequence, use SEARch:TRIGger:SENT:
TRANsmission.
Parameters:
<TSFieldType> STAT | STDA
STAT
Searches on the status nibble.
STDA
Searches for the end of the combination of status and data nib-
ble(s).
Define the data conditions with SEARch:TRIGger:SENT:
STATus, SEARch:TRIGger:SENT:TDCN, BUS<m>:SENT:
DNIBbles, SEARch:TRIGger:SENT:TDMN and SEARch:
TRIGger:SENT:TDMX.
*RST: STAT
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:STATus <SearchName>,<StatusBits>
SEARch:TRIGger:SENT:STATus? <SearchName>
Sets the status nibble data.
Parameters:
<StatusBits> Numeric or string pattern, Chapter 18.4.6, "Bit pattern parame-
ter", on page 1076. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
Protocols