Rohde & Schwarz RTE Series - Page 1725

Remote control commands
R&S
®
RTE
1725User Manual 1326.1032.02 ─ 20
INRange | OORange
In range / Out of range. To define the range set the minimum
and maximum values with SEARch:TRIGger:SENT:SDMN and
SEARch:TRIGger:SENT:SDMX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:SDMN <SearchName>,<SMDataPattern>
SEARch:TRIGger:SENT:SDMN? <SearchName>
Specifies a data pattern, or sets the start value of a data pattern range.
Parameters:
<SMDataPattern> Numeric or string pattern, Chapter 18.4.6, "Bit pattern parame-
ter", on page 1076. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:SDMX <SearchName>,<SMDataPatternTo>
SEARch:TRIGger:SENT:SDMX? <SearchName>
Sets the end value of an identifier range for SEARch:TRIGger:SENT:SDCN
INRange or OORange.
Parameters:
<SMDataPatternTo> Numeric or string pattern, Chapter 18.4.6, "Bit pattern parame-
ter", on page 1076. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:PULSeerror <SearchName>,<CalibPulseError>
SEARch:TRIGger:SENT:PULSeerror? <SearchName>
Enables the search for calibration pulse errors.
To initially enable the search for an error event, set SEARch:TRIGger:SENT:ERRor
to ON.
Parameters:
<CalibPulseError> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols