Rohde & Schwarz RTE Series - Page 1768

Remote control commands
R&S
®
RTE
1768User Manual 1326.1032.02 ─ 20
INRange | OORange
In range, out of range. These conditions require a range of end-
point values to be set using SEARch:TRIGger:CMSB:
FRAMe<m>:FLD<n>:DMIN and SEARch:TRIGger:CMSB:
FRAMe<m>:FLD<n>:DMAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CMSB:FRAMe<m>:ENABle
<SearchName>,<Enable>
SEARch:TRIGger:CMSB:FRAMe<m>:ENABle? <SearchName>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:ENABle
<SearchName>,<CondEnabler>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:ENABle? <SearchName>
Enables or disables the checking condition for searching a specific data pattern in the
selected field of the selected frame.
Suffix:
<m>
.
*
<n> *
Parameters:
<CondEnabler> ON | OFF
ON
Checking condition enabled
OFF
Checking condition disabled
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IMAX <SearchName>,<IndexMax>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:IMAX? <SearchName>
SEARch:TRIGger:CMSB:IMAX <SearchName>,<Frame>, <Field>, <Data>
Sets the end value of the bit index range (data position range), if SEARch:TRIGger:
CMSB:IOPerator is set to INRange.
Setting parameters:
<SearchName>
<Frame>
<Field>
<Data>
Usage: Setting only
Protocols