Rohde & Schwarz RTE Series - Configuration; MDIO (Option R&S RTE-K55)

Remote control commands
R&S
®
RTE
1776User Manual 1326.1032.02 ─ 20
18.17.16 MDIO (option R&S RTE-K55)
● Configuration.......................................................................................................1776
● Trigger.................................................................................................................1778
● Decode results.................................................................................................... 1781
● Search settings................................................................................................... 1784
● Search results..................................................................................................... 1787
18.17.16.1 Configuration
In all BUS<m>:MDIO commands, the suffix <m> selects the serial bus.
BUS<m>:MDIO:CLOCk:SOURce...................................................................................1776
BUS<m>:MDIO:DATA:SOURce.....................................................................................1776
BUS<m>:MDIO:CLOCk:THReshold:HIGH...................................................................... 1777
BUS<m>:MDIO:CLOCk:THReshold:LOW.......................................................................1777
BUS<m>:MDIO:DATA:THReshold:HIGH.........................................................................1777
BUS<m>:MDIO:DATA:THReshold:LOW......................................................................... 1778
BUS<m>:MDIO:PRESet............................................................................................... 1778
BUS<m>:MDIO:COUPling............................................................................................ 1778
BUS<m>:MDIO:CLOCk:SOURce <SourceClock>
Selects the source for the clock line (management data clock, MDC). Permitted selec-
tions are the analog channels "C1"–"C4" and the digital channels "D0"–"D15".
Suffix:
<m>
.
1..4
Parameters:
<SourceClock> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
Digital and analog channels cannot be used at the same time for
data and clock lines. For triggering on a serial bus, analog or
digital input channels are required.
See Chapter 18.4.2, "Waveform parameter", on page 1074
*RST: C2W1
BUS<m>:MDIO:DATA:SOURce <SourceData>
Selects the source for the data signal. Permitted selections are the analog channels
"C1"–"C4" and the digital channels "D0"–"D15", but not the same as for "Clock".
Suffix:
<m>
.
1..4
Protocols