Rohde & Schwarz RTE Series - Page 1822

Remote control commands
R&S
®
RTE
1822User Manual 1326.1032.02 ─ 20
PING
Searches for any high speed flow control probe for a bulk/control
endpoint
*RST: PREamble
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:STCO <SearchName>,<SC>
SEARch:TRIGger:USB:STCO? <SearchName>
Defines, which Start- / Complete- (SC) split transaction type is searched for: SSPLIT or
CSPLIT.
Parameters:
<SC> ONE | ZERO | DC
ONE
SC = 1 represents a complete-split (CSPLIT) transaction
ZERO
SC = 0 represents a start-split (SSPLIT) transaction
DC
SC = X represents "don't care" (DC)
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:STOKen <SearchName>,<TokenPacket>
SEARch:TRIGger:USB:STOKen? <SearchName>
Defines, whether a search for any token packet shall be activated or not.
Parameters:
<TokenPacket> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:TCONdition <SearchName>,<OperatorET>
SEARch:TRIGger:USB:TCONdition? <SearchName>
Sets the operator to set a specific endpoint type (ET) or an ET range. The ET values
are set with SEARch:TRIGger:USB:TMIN and SEARch:TRIGger:USB:TMAX.
Parameters:
<OperatorET> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The endpoint type is not relevant for the search condition.
Protocols