Rohde & Schwarz RTE Series - Decode Results

Remote control commands
R&S
®
RTE
1839User Manual 1326.1032.02 ─ 20
TRIGger<m>:USBPd:IMIN <Frame>, <Field>, <Data>
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IMIN <IndexMin>
Specifies the index, or sets the start value of an index range.
Suffix:
<m>
.
1..3
<n> *
Specifies the field number within the frame.
<o> *
Parameters:
<IndexMin> Specifies the index value or index start value within the field.
The index range, increment and *RST values depend on the
field type.
TRIGger<m>:USBPd:IOPerator <Frame>, <Field>, <Operator>
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:IOPerator <IndexOperator>
TRIGger<m>:USBPd:FRAMe<n>:FLD<o>:BIT <BitState>
Sets the bit state for the field.
Suffix:
<m>
.
1..3
<n> *
<o> *
Parameters:
<BitState> ONE | ZERO | DC
*RST: DC
18.17.18.3 Decode results
In all BUS<m>:USBPd:RESult:FRAMe<n> commands, the suffix <m> selects the
serial bus and the suffix <n> selects the frame number in the decode table.
BUS<m>:USBPd:RESult:FCOunt?.................................................................................1840
BUS<m>:USBPd:RESult:FRAMe<n>:DATA?.................................................................. 1840
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:FVAL?......................................................1840
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:STATus?...................................................1840
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:STARt?.....................................................1841
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:STOP?.....................................................1841
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:TYPE?..................................................... 1842
BUS<m>:USBPd:RESult:FRAMe<n>:FLD<o>:VAL?........................................................1842
BUS<m>:USBPd:RESult:FRAMe<n>:INFO?...................................................................1842
BUS<m>:USBPd:RESult:FRAMe<n>:STARt?................................................................. 1843
BUS<m>:USBPd:RESult:FRAMe<n>:STATe?................................................................. 1843
BUS<m>:USBPd:RESult:FRAMe<n>:STOP?..................................................................1843
BUS<m>:USBPd:RESult:FRAMe<n>:TYPE?..................................................................1844
Protocols