Rohde & Schwarz RTE Series - Decode Results

Remote control commands
R&S
®
RTE
1862User Manual 1326.1032.02 ─ 20
18.17.19.3 Decode results
BUS<m>:SWIRe:RESults:FCOunt................................................................................. 1862
BUS<m>:SWIRe:RESults:FRAMe<n>:DATA?................................................................. 1862
BUS<m>:SWIRe:RESults:FRAMe<n>:STARt?................................................................1862
BUS<m>:SWIRe:RESults:FRAMe<n>:STATe?................................................................1863
BUS<m>:SWIRe:RESults:FRAMe<n>:STOP?................................................................ 1863
BUS<m>:SWIRe:RESults:FRAMe<n>:TYPE?.................................................................1864
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:FVAL?.....................................................1864
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:STARt?................................................... 1865
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:STATus?................................................. 1865
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:STOP?....................................................1866
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:TYPE?.................................................... 1866
BUS<m>:SWIRe:RESults:FRAMe<n>:FLD<o>:VAL?.......................................................1866
BUS<m>:SWIRe:RESults:FCOunt <Key>
Returns the number of decoded frames for the selected serial bus.
Suffix:
<m>
.
1..4
Setting parameters:
<Key>
Return values:
<Count>
BUS<m>:SWIRe:RESults:FRAMe<n>:DATA?
Returns the data value.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<Data> 8-bit data value
Example:
BUS:SWIRe:RESults:FRAMe2:DATA?
<-- #H12
Usage: Query only
BUS<m>:SWIRe:RESults:FRAMe<n>:STARt?
Returns the start time of the specified frame.
Protocols