Rohde & Schwarz RTE Series - Page 1875

Remote control commands
R&S
®
RTE
1875User Manual 1326.1032.02 ─ 20
Parameters:
<Polarity> NORMal | INVert
*RST: NORMal
BUS<m>:CXPI:THReshold <Threshold>
Sets the threshold value for the signal.
Suffix:
<m>
.
1..4
Parameters:
<Threshold> Range: -15 to 12
Increment: 0.01
*RST: 6
Default unit: V
BUS<m>:CXPI:SDATa <SourceData>
Selects the input channel for the signal.
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Alternatively, digital channels can be used if MSO option R&S RTE-B1 is installed. Dig-
ital and analog channels cannot be used at the same time.
For triggering on a serial bus, analog or digital channel sources are required.
Suffix:
<m>
.
1..4
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
For triggering on a serial bus, analog or digital channel sources
are required.
*RST: C1W1
BUS<m>:CXPI:IBS:MAX <ExpectedIBSMax>
Sets the maximum for the inter-byte-space range.
Suffix:
<m>
.
1..4
Parameters:
<ExpectedIBSMax> Range: 0 to 15
Increment: 1
*RST: 10
Protocols