Rohde & Schwarz RTE Series - Page 1883

Remote control commands
R&S
®
RTE
1883User Manual 1326.1032.02 ─ 20
TRIGger<m>:CXPI:FID:CONDition <FrameIDOperator>
Set the condition for the frame ID. You can define an exact value or a value range.
Suffix:
<m>
.
1..3
Parameters:
<FrameIDOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:CXPI:FID:MIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:CXPI:FID:MIN and
TRIGger<m>:CXPI:FID:MAX.
*RST:
EQUal
TRIGger<m>:CXPI:FID:MAX <FrameIDMax>
Sets the end value of a frame ID range if TRIGger<m>:CXPI:FID:CONDition is set
to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<FrameIDMax>
TRIGger<m>:CXPI:FID:MIN <FrameIDMin>
Specifies a frame ID pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<FrameIDMin>
TRIGger<m>:CXPI:NM <NM>
Sets the value of the network management (NM) field.
Suffix:
<m>
.
1..3
Parameters:
<NM>
Protocols