Rohde & Schwarz RTE Series - Decode Results

Remote control commands
R&S
®
RTE
1885User Manual 1326.1032.02 ─ 20
18.17.20.3 Decode results
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1421
BUS<m>:CXPI:RESult:FCOunt?....................................................................................1885
BUS<m>:CXPI:RESult:FRAMe<n>:DATA?..................................................................... 1885
BUS<m>:CXPI:RESult:FRAMe<n>:DLCV?.....................................................................1885
BUS<m>:CXPI:RESult:FRAMe<n>:STARt?.................................................................... 1886
BUS<m>:CXPI:RESult:FRAMe<n>:STATe?.................................................................... 1886
BUS<m>:CXPI:RESult:FRAMe<n>:STOP?.....................................................................1886
BUS<m>:CXPI:RESult:FRAMe<n>:TYPE?.....................................................................1887
BUS<m>:CXPI:RESult:FRAMe<n>:WORD<o>:STATus?..................................................1887
BUS<m>:CXPI:RESult:FRAMe<n>:WORD<o>:TYPE?.................................................... 1887
BUS<m>:CXPI:RESult:FRAMe<n>:WORD<o>:VALue?................................................... 1888
BUS<m>:CXPI:RESult:FCOunt?
Returns the number of frames in the acquisition.
Suffix:
<m>
.
1..4
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:CXPI:RESult:FRAMe<n>:DATA?
Returns the data bytes of the specified frame.
Suffix:
<m>
.
1..4
<n> *
Return values:
<Data>
Usage: Query only
BUS<m>:CXPI:RESult:FRAMe<n>:DLCV?
Returns the data length code/ extension data length code field value.
Suffix:
<m>
.
1..4
<n> *
Protocols