Rohde & Schwarz RTE Series - Page 1889

Remote control commands
R&S
®
RTE
1889User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:CXPI:FID:CONDition..........................................................................1894
SEARch:TRIGger:CXPI:FID:MAX.................................................................................. 1895
SEARch:TRIGger:CXPI:FID:MIN................................................................................... 1895
SEARch:TRIGger:CXPI:NM.......................................................................................... 1895
SEARch:TRIGger:CXPI:TYPE.......................................................................................1896
SEARch:TRIGger:CXPI:CT <SearchName>,<CT>
SEARch:TRIGger:CXPI:CT? <SearchName>
Sets the value of the counter (CT), 2 bits indicating the continuity of the frame.
Parameters:
<CT>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DATA:DCONdition
<SearchName>,<DataOperator>
SEARch:TRIGger:CXPI:DATA:DCONdition? <SearchName>
Sets the condition for the data pattern. You can define no value, an exact value or a
value range.
Parameters:
<DataOperator> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
Any data pattern is considered
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:CXPI:
DATA:DMIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:CXPI:DATA:DMIN and
SEARch:TRIGger:CXPI:DATA:DCONdition.
*RST:
OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:DATA:DMAX <SearchName>,<DataMax>
SEARch:TRIGger:CXPI:DATA:DMAX? <SearchName>
Sets the end value of a data type range if SEARch:TRIGger:CXPI:DATA:
DCONdition is set to INRange or OORange.
Parameters:
<DataMax>
Protocols