Rohde & Schwarz RTE Series - Pattern Generator Setup

Remote control commands
R&S
®
RTE
1936User Manual 1326.1032.02 ─ 20
Suffix:
<m>
.
1..2
Parameters:
<WaveformSource> ARBitrary | SCOPe
ARBitrary
Enables you to load an existing arbitrary file.
SCOPe
Enables you to load a scope waveform.
*RST: ARBitrary
18.19.2
Pattern generator setup
PGENerator:BITRate....................................................................................................1936
PGENerator:ENABle.................................................................................................... 1936
PGENerator:FILE:OPEN...............................................................................................1936
PGENerator:FILE[:NAME].............................................................................................1936
PGENerator:HLEVel.....................................................................................................1937
PGENerator:PRESet.................................................................................................... 1937
PGENerator:RUNMode.................................................................................................1937
PGENerator:BITRate <BitRate>
Sets the number of transmitted bits per second for the pattern generator.
Parameters:
<BitRate> Range: 1 to 40E+6
Increment: 10
*RST: 1E+6
Default unit: bps
PGENerator:ENABle <State>
Enables the pattern generator and outputs the waveform.
Parameters:
<State> ON | OFF
PGENerator:FILE:OPEN
Loads the specified pattern file to the instrument.
Usage:
Event
Asynchronous command
PGENerator:FILE[:NAME] <FilePath>
Specifies a file path to open a pattern generator file.
Waveform generator (option R&S
RTE-B6)