Rohde & Schwarz RTE Series - Output Setup

Remote control commands
R&S
®
RTE
1937User Manual 1326.1032.02 ─ 20
Parameters:
<FilePath> String with the name of the file.
PGENerator:HLEVel <HighLevel>
Sets the high level of the pattern generator signal.
Parameters:
<HighLevel> Range: 1.2 to 5
Increment: 0.1
*RST: 1.2
Default unit: V
PGENerator:PRESet
Sets the default pattern generator settings.
Usage:
Event
PGENerator:RUNMode <RunMode>
Sets the duration for which the signal of the pattern generator will be output after the
trigger event.
Parameters:
<RunMode> SINGle | CONTinuous
*RST: CONTinuous
18.19.3 Output setup
WGENerator<m>:OUTPut[:LOAD]................................................................................. 1937
WGENerator<m>:VOLTage[:VPP]..................................................................................1938
WGENerator<m>:VOLTage:DCLevel..............................................................................1938
WGENerator<m>:VOLTage:HIGH.................................................................................. 1938
WGENerator<m>:VOLTage:INVersion............................................................................ 1938
WGENerator<m>:VOLTage:LOW...................................................................................1939
WGENerator<m>:VOLTage:OFFSet...............................................................................1939
WGENerator<m>:OUTPut[:LOAD] <Load>
Sets the load of the DUT at its connection.
Suffix:
<m>
.
1..2
Parameters:
<Load> FIFTy | HIZ
HIZ: high input impedance
*RST: HIZ
Waveform generator (option R&S RTE-B6)