Rohde & Schwarz RTE Series - Turn On;Off

Remote control commands
R&S
®
RTE
1965User Manual 1326.1032.02 ─ 20
Parameters:
<Volt> Range: 1E-3 to 1000
Increment: 0
*RST: 1E-3
Default unit: V
POWer:SOA:MASK <EnableMaskTest>
Activates or deactivates a mask.
Parameters:
<EnableMaskTest> ON | OFF
*RST: OFF
POWer:SOA:REPort:ADD
Adds the result to the report list.
Usage:
Event
POWer:SOA:SCALe <Scale>
Sets the scale for the measurement.
Parameters:
<Scale> LOG | LINEAR
*RST: LOG
POWer:SOA:SWITch <Switch>
Switches between linear and logarithmic scale.
Parameters:
<Switch> LOGLINEAR | LINEARLOG
*RST: LOGLINEAR
18.20.11 Turn on/off
This measurement is a single shot measurement. To start the measurement, use the
RUNS command.
POWer:ONOFf:ATOFf.................................................................................................. 1966
POWer:ONOFf:ATON...................................................................................................1966
POWer:ONOFf:DTOFf..................................................................................................1966
POWer:ONOFf:DTON...................................................................................................1966
POWer:ONOFf:DSOFf..................................................................................................1966
POWer:ONOFf:DSON.................................................................................................. 1966
POWer:ONOFf:EXECute.............................................................................................. 1966
POWer:ONOFf:INPut....................................................................................................1966
Power analysis (option R&S
RTE-K31)