Rohde & Schwarz RTE Series - Spectrum

Remote control commands
R&S
®
RTE
1981User Manual 1326.1032.02 ─ 20
POWer:TRANsient:TRGLevel <TriggerLevel>
Parameters:
<TriggerLevel> Range: -1000 to 1000
Increment: 1E-3
*RST: 0
Default unit: V
POWer:TRANsient:TRGSlope <TriggerSlope>
Sets the edge type for the trigger event.
Parameters:
<TriggerSlope> POSitive | NEGative | EITHer
*RST: POSitive
18.20.16 Spectrum
POWer:SPECtrum:AUToscale....................................................................................... 1981
POWer:SPECtrum:EXECute......................................................................................... 1981
POWer:SPECtrum:FREQuency.....................................................................................1981
POWer:SPECtrum:REPort:ADD.................................................................................... 1982
POWer:SPECtrum:RCOunt?.........................................................................................1982
POWer:SPECtrum:RESult<m>:FREQuency?..................................................................1982
POWer:SPECtrum:RESult<m>:LEVel?...........................................................................1982
POWer:SPECtrum:AUToscale <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:SPECtrum:EXECute
Starts the spectrum measurement.
Usage:
Event
POWer:SPECtrum:FREQuency <SmpsFrequency>
Sets the SMPS switching frequency.
Parameters:
<SmpsFrequency> Range: 1 to 100E+6
Increment: 1
*RST: 1E+6
Default unit: Hz
Power analysis (option R&S RTE-K31)