Rohde & Schwarz RTE Series - Standard Commands

Remote control commands
R&S
®
RTE
1990User Manual 1326.1032.02 ─ 20
If you want to start tracing already during startup of the instrument, configure all set-
tings (including start mode AUTO). Then restart your instrument. Tracing will be started
automatically during the restart, using the already configured settings.
If you use an XML file as trace file, ensure that tracing is stopped properly. If tracing is
aborted instead of stopped, for example by shutting down the instrument for stop mode
EXPLicit, the XML file will be invalid, because some tags are not closed.
When the maximum file size is reached (except for stop mode BUFFerfull) or if trac-
ing is started with an already existing trace file, a backup of the trace file is created and
the file itself is reset and overwritten. When the file is full for the second time or when
tracing is started the next time, the first backup file is lost because it is overwritten by
the next backup. In order to prevent loss of data, set a sufficient file size, select an
appropriate stop mode and archive/copy completed trace files if you want to keep
them.
18.23.1 Standard commands
TRACe:REMote:MODE:FILE:NAME.............................................................................. 1990
TRACe:REMote:MODE:FILE:FORMat............................................................................1990
TRACe:REMote:MODE:FILE:SIZE.................................................................................1990
TRACe:REMote:MODE:FILE:STARtmode...................................................................... 1991
TRACe:REMote:MODE:FILE:STOPmode.......................................................................1991
TRACe:REMote:MODE:FILE:ENABle............................................................................ 1991
TRACe:REMote:MODE:FILE:FILTer...............................................................................1991
TRACe:REMote:MODE:FILE:NAME <FilePath>
Sets the directory and file name where the remote trace file is stored.
Parameters:
<FilePath> String parameter
TRACe:REMote:MODE:FILE:FORMat <Format>
Sets the file format of the remote trace file.
Parameters:
<Format> ASCii | XML
TRACe:REMote:MODE:FILE:SIZE <FileSize>
Sets the maximum size of the remote trace file.
Parameters:
<FileSize> Integer value
Remote trace