Rohde & Schwarz RTE Series - R&S RT-ZHD High-Voltage Differential Probes

Acquisition and waveform setup
R&S
®
RTE
205User Manual 1326.1032.02 ─ 20
Copy to offset
Sets the measured ProbeMeter value as offset. Thus, the value is considered in mea-
surements.
If the probe is connected to the external trigger input, the function is not available.
Remote command:
PROBe<m>:SETup:ADVanced:PMToffset on page 1133
5.5.4.4 R&S RT-ZHD high-voltage differential probes
Figure 5-13: Probe setup for R&S RT-ZHD probes
The offset is the differential offset. See "Offset" on page 187.
Specific settings for R&S RT-ZHD probes are the following:
Range
Sets the voltage range of a R&S RT-ZHD probe. You can set the range on the probe
control box or at the oscilloscope.
"Auto"
The voltage range is set only at the oscilloscope with "Vertical scale".
"Low"
Sets the lower voltage range of the connected probe. The selected
value is shown in "Auto Attenuation".
"High"
Sets the higher voltage range of the connected probe. The selected
value is shown in "Auto Attenuation".
Remote command:
PROBe<m>:SETup:ADVanced:RANGe on page 1134
Probes