Rohde & Schwarz RTE Series - Probe Attributes

Acquisition and waveform setup
R&S
®
RTE
215User Manual 1326.1032.02 ─ 20
Figure 5-18: Probe setup for an unknown probe
Set the unit and the attenuation or gain of the probe: "Vertical unit, Attenuation, Gain"
on page 201.
5.5.9 Probe attributes
The "Probe Attributes" tab provides an overview of all R&S probes connected to an
input channel.
For a specification of the probe parameters, refer to the data sheet.
Remote commands:
●
PROBe<m>:ID:SWVersion? on page 1141
●
PROBe<m>:ID:PRDate? on page 1141
Probes