Rohde & Schwarz RTE Series - Page 219

Acquisition and waveform setup
R&S
®
RTE
219User Manual 1326.1032.02 ─ 20
Make sure that the tab of the correct probe is selected on the left side.
State
Enables the corresponding channel of the probe. The number of available channels
depend on the characteristics of your multi-channel power probe.
Remote command:
ZVC:Z<m>:V<n>[:STATe] on page 1153
ZVC:Z<m>:I<n>[:STATe] on page 1150
Scale
Defines the vertical scale for the channel in Volts per division. Increasing the scale
compresses the display of the signal. Within a given operation range, modifying the
scale is equivalent to scaling a display range.
For the voltmeter channels, the Scale, the Offset and the "Position" specify the operat-
ing range of the voltmeter.
Remote command:
ZVC:Z<m>:V<n>:SCALe on page 1152
ZVC:Z<m>:I<n>:SCALe on page 1148
Offset
The vertical center of the selected channel is shifted by the offset value and the signal
is repositioned within the diagram area. Negative offset values move up the waveform,
positive values move it down.
Within a given operation range, modifying the offset is equivalent to moving vertically
the display range. The offset can only be modified such that the display range reaches
at most the limits of the operation range.
R&S
RT-ZVC probe