Waveform analysis
R&S
®
RTE
285User Manual 1326.1032.02 ─ 20
2. Touch the position that you want to define as one corner of the zoom area. Then
drag your finger to the opposite corner of the zoom area.
While you drag your finger on the touchscreen, a dotted rectangle indicates the
current zoom area. When the rectangle covers the required zoom area, remove
your finger.
The indicated area is magnified in a new zoom diagram. The original diagram is
displayed with the zoom area indicated as a rectangle.
Figure 7-3: Zoom diagram and overview diagram
3. If the position of the zoom area is not correct, drag the rectangle in the overview to
the correct position.
4. If the size of the zoom area is not yet ideal, tap the rectangle in the overview dia-
gram.
Now, 4 red lines indicate the edges of the zoom area. A dashed red line indicates
the selected edge, which you can adjust.
Figure 7-4: Zoom area indicated by edges
Note: Tapping the zoom area toggles between area and edge adjustment.
Zoom
To Next Page
Loading...
