Rohde & Schwarz RTE Series - Scaling

Waveform analysis
R&S
®
RTE
293User Manual 1326.1032.02 ─ 20
Remote command:
REFCurve<m>:SOURce on page 1220
Update with selected source
Copies the selected source waveform with all its settings to the memory of the refer-
ence waveform. If the acquisition is running, the reference waveform is a snapshot.
Remote command:
REFCurve<m>:UPDate on page 1222
Show reference waveform
Displays the reference waveform in the diagram.
Remote command:
REFCurve<m>:STATe on page 1221
Clear reference waveform
The selected reference waveform disappears, its memory is deleted.
Remote command:
REFCurve<m>:CLEar on page 1222
Save to or load from file
Enter the filename of the stored reference waveform and select the file format with the
format button on the right. Double-tap the filename to open the file selection dialog box,
see also Chapter 12.7, "File selection dialog", on page 511.
By default, the filename has the prefix "RefCurves_". You can define a pattern for auto-
matic naming in the "Autonaming" tab.
Note: Note that reference waveforms can be loaded from .bin files only. xml and csv
formats are meant for further processing in other applications.
"Load"
Loads the specified reference waveform.
"Open"
Opens a file selection dialog box and loads the selected reference
waveform file.
"Save"
Saves the waveform as a reference waveform in the selected file.
"Save As..."
Opens the file selection dialog box and saves the waveform to the
selected file.
".bin/.xml/.csv"
Selects the file format.
Remote command:
REFCurve<m>:OPEN on page 1221
REFCurve<m>:SAVE on page 1222
REFCurve<m>:DELete on page 1222
7.2.2.2 Scaling
A reference waveform can have its own vertical and horizontal offset.
Reference waveforms