Rohde & Schwarz RTE Series - Page 328

Measurements
R&S
®
RTE
328User Manual 1326.1032.02 ─ 20
Type
Defines the cursor type to be used for the measurement.
●
Horizontal cursors (Y-cursors)
Horizontal cursors are positioned automatically along the waveform and can be
adjusted manually
●
Vertical cursors (X-cursors)
Both vertical cursor lines are set automatically to the trigger position, and you can
reposition them manually.
●
Both vertical and horizontal cursors (X&Y-cursors)
Horizontal cursors are positioned automatically along the waveform and vertical
cursors are set to the trigger position. You can reposition all cursor lines manually.
Remote command:
CURSor<m>:FUNCtion on page 1239
Cursor style
Defines how the cursor is displayed in the diagram.
"Lines"
The cursors are displayed as lines.
"Line & Rhom-
bus"
The cursors are displayed as lines. The intersections of the cursors
with the waveforms are displayed by rhombus-shaped points.
"Vertical line
and rhombus"
The cursors are displayed as vertical lines. The intersections of the
cursors with the waveforms are displayed by rhombus-shaped points.
"Rhombus"
The intersections of the cursors with the waveforms are displayed by
rhombus-shaped points.
Remote command:
CURSor<m>:STYLe on page 1244
Source
Defines the source of the cursor measurement. Any of the input signal, math, reference
or XY waveforms can be selected.
Remote command:
CURSor<m>:SOURce on page 1240
2nd Source
Enables and selects a second source for the cursor measurements. If enabled, the
second cursor lines Cx.2 measure on the second source. Using a second source, you
can measure differences between two channels with cursors.
Remote command:
CURSor<m>:USSource on page 1241
CURSor<m>:SSOurce on page 1240
X position 1, X position 2
Defines the position of the vertical cursors.
Remote command:
CURSor<m>:X1Position on page 1241
CURSor<m>:X2Position on page 1242
Cursor measurements