Rohde & Schwarz RTE Series - Amplitude;Time Measurements; Overview of Amplitude;Time Measurements

Measurements
R&S
®
RTE
349User Manual 1326.1032.02 ─ 20
Remote command:
REFLevel<m>:ABSolute:LOW on page 1311
Middle
The middle level between high and low signal level. The value is adjusted automati-
cally if you change the high or low signal levels. Vice versa, if you change the middle
level, the high and low signal levels are adjusted.
Remote command:
REFLevel<m>:ABSolute:MLEVel on page 1312
Top distance
The distance between the high signal level and the upper reference level - for manual
reference level mode and absolute level definition.
Remote command:
REFLevel<m>:ABSolute:TDIStance on page 1311
Bottom distance
The distance between the lower reference level and the low signal value - for manual
reference level mode and absolute level definition.
Remote command:
REFLevel<m>:ABSolute:BDIStance on page 1312
Histogram averaging
Enables averaging over several histograms to determine the reference levels.
This function is only available in automatic reference level mode.
Remote command:
REFLevel<m>:AUTO[:STATe] on page 1310
Average Count
Defines the number of histograms to calculate the average from.
This function is only available in automatic reference level mode.
Remote command:
REFLevel<m>:AUTO:COUNt on page 1310
8.2.5 Amplitude/time measurements
8.2.5.1 Overview of amplitude/time measurements
Access: "Meas" menu > "Setup" > "Amp/Time" category
Automatic measurements