Rohde & Schwarz RTE Series - Page 393

Measurements
R&S
®
RTE
393User Manual 1326.1032.02 ─ 20
If the check is enabled, a table is displayed where you can set the limit and margin val-
ues and the range of valid measurement results.
Limit check
Selects and enables the limit or margin check.
"Off"
No limit check is performed.
"Limit only"
Limits are checked for violation.
"Margin &
Limit"
Margins and limits are checked for violation.
Upper limit, Lower limit, Upper margin, Lower margin, Valid range
Set the limits and margins for each measurement, and also specify the valid range.
Upper limit
Upper margin
Lower margin
Lower limit
within
outside
outside
upper lower
Upper margin
Upper limit
Lower limit
Lower margin
Figure 8-14: Limit and margin definition
Automatic measurements