Rohde & Schwarz RTE Series - Enable Math Signal

Spectrum analysis
R&S
®
RTE
411User Manual 1326.1032.02 ─ 20
If no gate is used, you can define the record length as dependent on the RBW, or the
RBW as dependent on the record length (which is defined by the acquisition time).
Enable math signal......................................................................................................411
Use Gate.....................................................................................................................412
Gate Definition............................................................................................................ 412
└ Zoom coupling.............................................................................................. 412
└ Mode.............................................................................................................412
└ (Relative) Start..............................................................................................412
└ (Relative) Stop.............................................................................................. 413
Record Length/RBW Coupling....................................................................................413
Required acquisition time............................................................................................413
Enable math signal
If activated, a diagram for the defined math waveform is displayed on the touch screen.
Remote command:
CALCulate:MATH<m>:STATe on page 1227
FFT analysis