Rohde & Schwarz RTE Series - FFT Coupling

Spectrum analysis
R&S
®
RTE
416User Manual 1326.1032.02 ─ 20
Suppression
Enables noise suppression. Phase calculation is restricted to frequencies with a mini-
mum magnitude, the threshold value.
Remote command:
CALCulate:MATH<m>:FFT:PHASe:SUPPression on page 1326
Threshold
Defines the minimum frequency magnitude for which phases are calculated. This set-
ting is only available if "Suppression" is enabled.
Remote command:
CALCulate:MATH<m>:FFT:PHASe:THReshold on page 1326
9.1.3.6 FFT coupling
Access: [MATH] > "FFT Coupling"
Up to four spectrum displays can be shown simultaneously, one for each math wave-
form. The settings for one or more spectrums can be coupled. Thus, if any FFT setting
for any of the coupled spectrums are changed, they are changed for all coupled spec-
trums.
Enable math signal
If activated, a diagram for the defined math waveform is displayed on the touch screen.
Remote command:
CALCulate:MATH<m>:STATe on page 1227
FFT analysis