Rohde & Schwarz RTE Series - Creating User Masks; Setting up User Masks; Working with Masks

Mask testing
R&S
®
RTE
436User Manual 1326.1032.02 ─ 20
Color
Sets the color of samples that violated the mask.
Remote command:
MTESt:COLor:MATCh on page 1347
Mask without violation
Sets the color of masks segments that were not hit.
Remote command:
MTESt:COLor:UNMatch on page 1347
Mask with violation
Sets the color of mask segments the signal has entered into.
Remote command:
MTESt:COLor:INTerior on page 1348
Mask with contact
Sets the color of masks segments that were touched at the border. In this case, the
resolution is not sufficient to detect if the mask was hit or not. Zoom into the concerned
area to see the actual result.
Remote command:
MTESt:COLor:BORDer on page 1348
10.3 Working with masks
This chapter explains step-by-step how mask tests are setup and preformed. For the
explanation of the individual settings, see Chapter 10.2, "Mask test settings",
on page 424.
● Setting up user masks...........................................................................................436
● Setting up a mask test...........................................................................................440
● Configuring the mask and hit display.................................................................... 441
● Running a mask test............................................................................................. 442
● Saving and loading masks.................................................................................... 443
● Mask testing on history acquisitions......................................................................443
10.3.1 Setting up user masks
10.3.1.1 Creating user masks
There are two ways to create a new mask:
●
Graphical way by tapping the mask points on the touchscreen,
●
Numerical entry of the x- and y-values of the mask points.
Working with masks