Data and file management
R&S
®
RTE
487User Manual 1326.1032.02 ─ 20
If multiple acquisitions of one waveform are exported into a BIN file, the first acquisition
can be reloaded as reference waveform.
"Data logging" enables the export of all waveforms of an Nx Single acquisition into one
file. The waveform records are written in historical order one after the other, either the
complete records or the sections as defined in "Scope". Set the number of acquisitions
to be acquired and stored with "Acq. count". The maximum amount of data that can be
written is shown in "Max. file size".
Enabling "Data logging" stops a running acquisition. To start the logging, tap Start
Export or press [RUN N× SINGLE].
Pressing "Run cont" disables data logging.
If "Export history" is enabled, the option "Multiple Wfms" allows you to save several or
all history waveforms. Define the part of the history to be exported using "Start acq"
and "Stop acq".
Remote command:
EXPort:WAVeform:DLOGging on page 1405
Start Export
Starts an Nx Single acquisition series and simultaneously saves the waveform data to
a file if data logging is enabled.
If "Export history" is enabled, the button starts the history replay and simultaneously
saves the history waveforms.
Remote command:
RUNSingle on page 1107 (Nx Single acquisition)
CHANnel<m>[:WAVeform<n>]:HISTory:PLAY on page 1233 (history export)
Export history
Enables the history mode and the export of history waveforms to file. The setting is
also available in the "History" dialog box under the designation" Show history".
To save one waveform from the history, enter the number of the required acquisition in
"Acq index", and tap "Save".
Waveform data and results
To Next Page
Loading...
