Rohde & Schwarz RTE Series - Symbolic Trigger; Symbolic Trigger, Decode and Search

Protocol analysis
R&S
®
RTE
593User Manual 1326.1032.02 ─ 20
Figure 13-27: Search result
13.5.7 Symbolic trigger, decode and search
The R&S RTE can read and apply industry-standard DBC files to the decoded signal
and provides settings for symbolic triggering and symbolic search.
For a description of DBC files, see Chapter 13.5.4.1, "DBC files for CAN / CAN FD",
on page 578.
13.5.7.1 Symbolic trigger
The "Symbolic" trigger type is available if a DBC label list file is loaded and applied. It
allows you to trigger on a specific data message, or a signal and its value that appears
inside the message.
Access: [PROTOCOL] > "Trigger" tab > "Source = Serial Bus" > select "Protocol =
CAN/ CAN-FD" and "Type" = "Symbolic"
CAN and CAN FD (option R&S RTE-K3/K9)