Rohde & Schwarz RTE Series - LIN Configuration; LIN Configuration Settings

Protocol analysis
R&S
®
RTE
601User Manual 1326.1032.02 ─ 20
Figure 13-31: Structure of a byte field
Data bytes are transmitted LSB first.
The identifier byte consists of 6 bits for the frame identifier and two parity bits. This
combination is known as protected identifier.
Trigger
The R&S RTE can trigger on various parts of LIN frames. The data line must be con-
nected to an input channel, triggering on math and reference waveforms is not possi-
ble.
You can trigger on:
●
Frame start (synchronization field)
●
Specific identifier or identifier range
●
Data pattern in the message
●
Wake up signal
●
Checksum error (error in data), parity error (error in identifier)
13.6.2 LIN configuration
13.6.2.1 LIN configuration settings
Access: [PROTOCOL] > "Decode" tab > "Protocol" = LIN
Make sure that the tab of the correct serial bus is selected.
LIN (option R&S RTE-K3)