Rohde & Schwarz RTE Series - Page 613

Protocol analysis
R&S
®
RTE
613User Manual 1326.1032.02 ─ 20
Column Description
Label Symbolic label name defined in the label list
Frame PID (hex) Protected identifier
Values Value of the data bytes. The data format is selected below the table.
Chks (hex) Checksum value
Bit rate Value of the bit rate
Enable "Show Details" in the decode table to display a more detailed analysis of the
selected frame. Details include the frame data, the label and the symbolic name.
Zooming on decoded results
The zoom functions allow you to analyze the decode results in more detail. If "Zoom
coupling" is enabled, the decode zoom and result table are synchronized; if you select
a row in the result table, this result is shown in the decode zoom.
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
LIN (option R&S
RTE-K3)