Rohde & Schwarz RTE Series - Page 615

Protocol analysis
R&S
®
RTE
615User Manual 1326.1032.02 ─ 20
Search types
Sets the type to be searched for.
"Start of frame
(Sync)"
Searches for the stop bit of the sync field.
"Identifier"
Searches for one specific identifier or an identifier range.
See "Identifier setup: Condition, Frame ID min, Frame ID max"
on page 616
"Identifier OR"
Searches for a combination of up to four identifiers.
See "Identifier OR setup: Monitor, Frame ID" on page 616
"Identifier +
Data"
Searches for a combination of identifier and data condition. The
instrument triggers at the end of the last byte of the specified data
pattern.
The identifier conditions are the same as for the "Identifier" trigger
type, see "Identifier setup: Condition, Frame ID min, Frame ID max"
on page 605.
Data conditions are set with "Data setup: Data length, Transfer, Con-
dition, Data min, Data max" on page 606.
"Wakeup
frame"
Searches for wakeup frames.
"Error condi-
tion"
Identifies various errors in the frame, see "Error conditions"
on page 607.
Remote command:
SEARch:TRIGger:LIN:SSOFrame on page 1545
SEARch:TRIGger:LIN:SFIDentifier on page 1546
SEARch:TRIGger:LIN:IDENtifieror on page 1546
SEARch:TRIGger:LIN:SIDData on page 1546
LIN (option R&S
RTE-K3)