Protocol analysis
R&S
®
RTE
652User Manual 1326.1032.02 ─ 20
The instrument uses the bus data format to interpret audio data ("Display" tab > "Data
format"). ASCII format is not supported.
Figure 13-42: Track of all 8 channels of a TDM signal
13.8.5.1 Displaying and configuring a track
To get a first impression of the track, you can display it quickly. For further analysis,
some configuration settings are available.
1. Press the [PROTOCOL] key.
2. Select the "Display" tab.
3. Tap the "Show Track Waveform(s)" button.
4. Select the "Audio channel" to be tracked.
The track waveform with default settings is enabled and displayed.
Tip: Alternatively, you can enable the track in the "Measurements" dialog box, on
the "Result Analysis" tab if the protocol measurement is selected on the "Setup"
tab.
5. If you want to change the track settings, tap "Track Setup".
Audio signals (option R&S
RTE-K5)
To Next Page
Loading...
