Protocol analysis
R&S
®
RTE
710User Manual 1326.1032.02 ─ 20
●
SEARch:RESult:ETHernet:WORD<m>:STATe? on page 1668
●
SEARch:RESult:ETHernet:WORD<m>:STARt? on page 1668
●
SEARch:RESult:ETHernet:WORD<m>:STOP? on page 1669
●
SEARch:RESult:ETHernet:WORD<m>:DESTaddress? on page 1669
●
SEARch:RESult:ETHernet:WORD<m>:SRCaddress? on page 1669
●
SEARch:RESult:ETHernet:WORD<m>:DATA? on page 1670
●
SEARch:RESult:ETHernet:WORD<m>:CRC? on page 1671
●
SEARch:RESult:ETHernet:WORD<m>:DSYMbol? on page 1671
●
SEARch:RESult:ETHernet:WORD<m>:SSYMbol? on page 1671
●
SEARch:RESult:ETHernet:WORD<m>:BYTE<n>:VALue? on page 1672
13.11.6.3 Searching Ethernet data
Prerequisite: A serial bus is configured for the Ethernet signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press [SEARCH] or tap "Search" > "Setup" in the menu bar.
2. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 460.
3. Tap "Source" and select the serial bus that is set to Ethernet (e.g. "SerBus1",
unless already selected).
The search dialog for Ethernet protocol analysis is opened.
4. Specify search criteria according to Chapter 13.11.6.1, "Ethernet search setup",
on page 707.
5. To acquire a waveform, press [RUN N× SINGLE].
The R&S RTE performs an Ethernet decode according to the thresholds and proto-
col settings of the associated serial bus source (here in our example SB1).
6. To start searching the acquired waveform for specific events, tap "Enable" in the
search setup dialog:
The R&S RTE displays the "Search Results" box that lists the detected events.
For information on how to configure the search results presentation and how to navi-
gate the search results, see also "To display search zoom windows" on page 466 and
"Navigating search results" on page 447.
Ethernet 10BASE-T and 100BASE-TX (option R&S
RTE-K8)
To Next Page
Loading...
