Protocol analysis
R&S
®
RTE
739User Manual 1326.1032.02 ─ 20
"Calibration or Sync"
Triggers at the end of the "Synchronization/Calibration" pulse.
This setting does not require any input parameters.
"Transmission Sequence"
Triggering depends on the additional selectable "Sequence" parame-
ter:
●
"Sequence > Status": triggers at the end of the "Status" nibble.
●
"Sequence > Status+Data": triggers at the end of the last data
nibble.
Description of trigger type specific settings: "Transmission Sequence
setup" on page 740
SENT (option R&S RTE-K10)
To Next Page
Loading...
