Protocol analysis
R&S
®
RTE
760User Manual 1326.1032.02 ─ 20
Search types
Enable the events to be searched for.
Unlike triggering, where you can trigger only on one defined event, you can search for
various different events in one search.
"Calibration Sync"
Searches for the end of the "Calibration/Synchronization" sequence,
i.e. the falling edge.
This setting does not require any input parameters.
"Transmission Seq"
Searches for the end of the status nibble in a single transmission
sequence, or the end of the combination of the status and data nib-
ble(s).
Description of the specific settings: "Transmission Sequence setup"
on page 761
"Serial Message"
Searching on a serial message depends on the serial protocol
selected with Serial protocol > Short | Enhanced and the associated
setting parameters:
●
"Sequence > Identifier": searches for the end of the identifier nib-
ble.
●
"Sequence > ID+Data": searches for the end of the "ID and Data"
nibble.
Description of the serial messages specific settings: "Serial Message
setup" on page 762
SENT (option R&S RTE-K10)
To Next Page
Loading...
