Getting started
R&S
®
RTE
78User Manual 1326.1032.02 ─ 20
3. To move the waveform back to the center of the screen, eliminate the offset in the
vertical settings:
a) Press the [Ch1] key again.
b) Enter 0
V in the "Offset" field.
The waveform is now displayed in the center of the display, with the x-axis crossing
at 0 V. The waveform can be unstable if the trigger level is above.
4. Tap the "Show signal bar" icon on the toolbar.
The signal bar disappears, and you can see the trigger level marker on the right.
Trying out the instrument
To Next Page
Loading...
