Protocol analysis
R&S
®
RTE
796User Manual 1326.1032.02 ─ 20
●
Each cell (row) is displayed as a honeycomb cell with the name in the header line
(2
nd
line in the honeycomb) and the formatted content in the value line (3
rd
line in
the honeycomb).
Since the frame description is customizable, the result table has to be mostly generic.
Due to the limited width of the result table, you have to select a limited number of
results to be displayed by specifying it in the frame description. For example, the three
results defined in the Result Column). This leads to a detailed view that shows all infor-
mation on a per-frame base.
Examples
The example in Figure 13-85 shows decoded and binary signals of a custom serial
bus. The format information of DALI is being used to display as a result.
Note that activating "Show details" in the decode table provides a more detailed analy-
sis of decode results for one selected frame. This brings up a list of the states and val-
ues of all cells of the selected frame (in binary format). With this details dialog open,
you can still click on the basic decode table, to change the selection of the frame to be
displayed in detail.
Figure 13-85: Decode results table and details of a "DALI" protocol sample waveform
In the honeycomb display,
Cells are shown in the Color that have been set in the
Frame format configuration.
For example, the result "array[297]" in "Frame 4", "Result 2" of the decoding table in
Figure 13-85, is the short name for an array field display, and the number in the brack-
ets indicates the length of the array, as described in Variable Length Array: [].
The tables "Decode results" and "Decode results details" in Figure 13-85 are described
in Table 13-16 and Table 13-17:
Custom: Manchester / NRZ (option R&S
RTE-K50)M
To Next Page
Loading...
