Rohde & Schwarz RTE Series - Spacewire Search Results

Protocol analysis
R&S
®
RTE
876User Manual 1326.1032.02 ─ 20
"Data Min/
Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.5, "Bit pattern editor", on page 521.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:SWIRe:DATA:CONDition on page 1867
SEARch:TRIGger:SWIRe:DATA:MAX on page 1868
SEARch:TRIGger:SWIRe:DATA:MIN on page 1868
Parity Error
Checks the parity of every frame and searches for even parity.
Remote command:
SEARch:TRIGger:SWIRe:ERRor:PARity on page 1869
ESC Error
Searches for an escape error.
Remote command:
SEARch:TRIGger:SWIRe:ERRor:ESC on page 1868
13.18.5.2 SpaceWire search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
The "Show search zoom windows" function allows you to analyze the search results in
more detail. Search zoom and result table are synchronized; if you select a row in the
result table, this result is shown in the search zoom.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 446
●
Chapter 11.4, "Result presentation", on page 463
Remote commands:
●
SEARch:RESult:SWIRe:FCOunt? on page 1870
●
SEARch:RESult:SWIRe:FRAMe<m>:DATA? on page 1871
●
SEARch:RESult:SWIRe:FRAMe<m>:STARt? on page 1871
●
SEARch:RESult:SWIRe:FRAMe<m>:STATe? on page 1871
●
SEARch:RESult:SWIRe:FRAMe<m>:STOP? on page 1872
●
SEARch:RESult:SWIRe:FRAMe<m>:TYPE? on page 1872
SpaceWire (option R&S
RTE-K65)