Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
933User Manual 1326.1032.02 ─ 20
Symmetry
Sets the symmetry for the ramp modulation waveform, the percentage of time that the
waveform is rising.
Remote command:
WGENerator<m>:MODulation:AM:SYMMetry on page 1927
Duty cycle
Sets the duty cycle for a square waveform. The duty cycle expresses for what percent-
age fraction of the period, the waveform is active, i.e. the signal state is high.
Remote command:
WGENerator<m>:MODulation:AM:DCYCle on page 1926
15.1.3.3 PWM modulation
For pulse width modulation (PWM), the time for which the signal is in a high state is
varied according to the modulation signal.
Modulation signal
Selects the type of the modulation signal for the PWM modulation types.
Remote command:
WGENerator<m>:MODulation:PWM[:FUNCtion] on page 1931
Modulation freq
Sets the frequency of the modulation waveform.
Setup of the waveform generator
To Next Page
Loading...
