Rohde & Schwarz RTE Series - Configuring a Pattern Generator Waveform; DC Offset Alignment

Waveform generator (Option R&S RTE-B6)
R&S
®
RTE
952User Manual 1326.1032.02 ─ 20
9. Press the "Enable" button, to output the waveform at the output connector of the
waveform generator.
15.4.5 Configuring a pattern generator waveform
1. Press the [Gen 1] key on the front panel.
2. At the left-hand side, select the vertical tab "PG".
3. Select the "Setup" tab.
4. Select the "Run mode".
5. Press "Open" and set the path to your saved pattern file.
6. Set the "Bit rate" and "High level".
7. Press "Open" and set the path to your saved arbitrary waveform.
8. Press the "Enable" button, to output the pattern at the output connector of the pat-
tern generator.
15.5 DC offset alignment
Access: "Wave Gen" > "DC offset allignment" tab
Start Alignement
Starts the alignment of the DC offset.
Remote command:
GENerator:ALIGnment:DC[:STARt] on page 1941
Date
Displays the date of the last performed DC offset alignment.
Remote command:
GENerator:ALIGnment:DC:RESult:DATE? on page 1941
DC offset alignment